Fractal Set-up

Printer problem - “I still have the printer problem where I can print the test page but not set printer as server default”
- Deleted test printer to make default to printer
Calibration - Overexposure/Apriltag cut off
- Turn down exposure on calibrate page
- Print calibration page to fit entire image
“Lots of flickering”
- Turn down camera exposure
Calibration, z plane camera close to projected screen
- Being able to recalibrate in the middle
Hardware set-up. Finding a good configuration
- Does webcam need to be perfectly perpendicular vertically?
- What makes sense for ultra short throw projects
  - Calibration challenges
What are the tolerances of the hardware?
- Webcam, projector, understanding the sizing of calibration sheet, april tags
Calibration challenges
- Lack of feedback
- Ultra short throw projectors towards the end of the screen
- Suggestions
  - Having a start-up page once calibration is successful
  - Feedback on the calibration stage, what we should be looking for
  - Maybe having quadrants or key points to get for calibration sheet
  - Overall having more feedback
- Webcam was too high up - meant the folk interface was extending far beyond the system